The
ADV1017 consists of  the master unit and eight remote identifiers. The
IDs are marked on the  identifiers.  This device is used to test LAN
cable with RJ45 connector  and PHONE cable with RJ11 connector.  The
device is connected to one end  of the testing cable and the remote
identifiers are connected to the  other end of the testing cables.
There are four faults that can be tested on each pair:  Overvoltage,
Open, Short, Reversed pair.



By analysis, test results for each pair can
help find more faults such  as: Crossed pair, Split pair, Transposed
pair, and Double split pair. To put tone on a cable, simply push and
hold down the "TEST" button  until the "TONE" LED lights. The device is
now transmitting tone on the  cable.  The "TONE" LED will flash
indicating that the tone mode is on.  Tone mode will automatically shut
off after approximately 30 minutes.   To exit the tone mode, push the
"TEST" button once. The "TONE" LED will  turn off.



    
Auto Power Off:   12 seconds after Pass/Fail results
    

    
    
Auto Power Off:  30 minutes in "Tone" mode 
    
Minimum cable length for testing:  0ft 
    
Maximum cable length for testing:  3000ft 
    
Maximum DC cable resistance (Shield + Center Conductor): 100  ohms
    
Dimensions 3-1/4" x 2" x 1-1/4" 
    
Weight: 4 oz (with battery)